Post
by Drofder2004 » September 25th, 2010, 9:33 pm
No, you cannot merge this anyway. you can only merge two brushes that will in turn form a valid brush.
As brushes cannot have "concave" sections and must have no more than 4 vertexes per face.
What you should really do is clean it up, there are way to many cuts going everywhere.
You should create a terrain patch in a same/similar shape.
Select the FACE of every brush, then "Face to terrain".
The press "v" and then weld all the vertices that are close to each other using "w".
Then finally select all and press "alt-g" to align to grid.
You can also try selecting a patch at a time and joining them by pressing "w" (without vertice mode on).
Virgin Media 20Mb Broadband:
"Perfect for families going online at the same time, downloading movies, online gaming and more."
Borked internet since: 22-07-2010