Stupid question

[Soviet]

I created an inverted bevel (and endcap, tried both) to a half cylinder. However, it was not squared off against the square walls I was lining it with. So, I tried to move the vertices, they wouldn't move. I can move them in rows, but I can't select a vertice unless I do the bounding box, but then I can't press it again to move it. Curious, I tried to move individual vertices with path and terrain meshes with the same results. It has nothing to do with the locking vertices controls either.

[Drofder2004]

Select the vertice then hold shift while dragging.

Failing that give me a screenshot as I do not fully follow.

[Soviet]

that worked, but the cap is evil and I can't move the vertices properly

edit: I got a round-about way to make it work...