![Smile :)](./images/smilies/icon_smile.gif)
Mapping
1. Create 2 big blocks on either side leaving the arch area
2. Create a block in the middle and drag the height to what u want the height of the arch
3. Patch > End cap
4. You may need to rotate this. But you may not need to. it depends
5. After youve rotated it see the gap above? simple to sort out
6. Click Patch > cap
7. then click "Inverted cap"
8. you just created a simple arch
![Smile :)](./images/smilies/icon_smile.gif)
any problems. post in this forum i will try to help
![Smile :)](./images/smilies/icon_smile.gif)