Hi when i bend a patch, to make a road for example, quite a lot of vertices arn't on the grid even when i go to grid 1 zoom in. They would be in the middle of the sqaure or near the edge but just doesnt touch the line.
Free movment thing not good, but ive seen somone apparently snapping the verticies to the grid. Any suggestions?
Verticies, Snap To Grid?
Moderator: Core Staff
-
- CJ Worshipper
- Posts: 383
- Joined: December 16th, 2005, 6:38 pm
-
- Core Staff
- Posts: 13313
- Joined: April 13th, 2005, 8:22 pm
- Location: UK, London
Method I use...
Create your bend using a patch to get a nice smooth bend.
Now create a terrain mesh on top, and manually move the terrain to fit the patch as close as possible.
Delete the patch.
Joining patches and terrain nicely is pretty much impossible, if things are not snapped together, the engine starts to draw shadows in bad places.
Create your bend using a patch to get a nice smooth bend.
Now create a terrain mesh on top, and manually move the terrain to fit the patch as close as possible.
Delete the patch.
Joining patches and terrain nicely is pretty much impossible, if things are not snapped together, the engine starts to draw shadows in bad places.
Virgin Media 20Mb Broadband:
"Perfect for families going online at the same time, downloading movies, online gaming and more."
Borked internet since: 22-07-2010
Who is online
Users browsing this forum: No registered users and 15 guests